Vaporesso GTi Dual Mesh Replacement Coils - 5 Pack

Dual mesh on the GTi platform

The GTi Dual Mesh coils from Vaporesso keep the base of GTi coils but heat through two stacked layers of mesh. Heat is spread evenly through the cotton, and Vaporesso claims a longer life than a single mesh. Sold in packs of 5, they are designed for direct-to-lung inhalation (DL), the vapour going straight into the lungs.

Three values, three ways of vaping

• 0.15ohm, from 75 to 90W: the biggest clouds and a very free draw
• 0.2ohm, from 60 to 75W: dense vapour and pronounced flavour, the value fitted as standard in the iTank T Dual Mesh
• 0.4ohm, from 50 to 60W: a more moderate setting for a calmer vape

The power range is engraved on each coil: start from the lowest figure, then adjust to your feel.

In the box

• 5 x GTi Dual Mesh coils in the value chosen

Compatibility

These coils come as standard with the iTank T Dual Mesh tank and the Armour Octa and Armour Ultra kits. They also fit the iTank T tank, supplied with the Armour Max, Armour S and GEN Max kits. Prefer a single mesh? The GTi coils share the same base. GTX and XROS coils are not compatible. More models are in the coils category.

Frequently asked questions

Can I put GTi Dual Mesh in an iTank T supplied with single-mesh coils?

Yes: Vaporesso states that the iTank T accepts the whole GTi platform. Prime the new coil and start again at the bottom of its range.

Which value should I choose to start with direct inhalation?

The 0.4ohm is the easiest to get used to: it works at lower power and gives measured vapour. Then move to the 0.2ohm, then to the 0.15ohm if you want more vapour.