Vaporesso iTank 2

This tank is no longer made by Vaporesso. Its replacement, the iTank T tank, takes the same GTi coils. It also comes as the iTank T Dual Mesh.

The iTank 2, large capacity and 810 drip tip for direct vaping

The iTank 2 tank from Vaporesso is designed for direct-to-lung inhalation (DL), where the vapour goes down in one go into the lungs. Its 8ml tank, under a bulb glass, supports heavy consumption without repeated refills. Its 810 drip tip, wider than a 510 tip, lets a large volume of vapour out without slowing it.

To pour in the e-liquid, a press on the top is enough to open the opening (Press and Auto-Open system): no tools, no part to remove. Inside, the GTi coils use a heating mesh that covers a large surface; the iTank 2 comes with a 0.2ohm and a 0.4ohm, two values designed for a box mod able to send out power.

Highlights

• 8ml capacity to space out refills
• Fill opening with a simple press
• 810 drip tip suited to big clouds
• Two GTi Mesh coils supplied
• 25.5mm diameter base

In the box

• 1 x iTank 2 tank
• 1 x GTi Mesh 0.2ohm coil (fitted)
• 1 x GTi Mesh 0.4ohm coil
• 1 x spare glass
• 3 x O-rings
• 1 x silicone filling plug
• 1 x user manual

Coils, glass and kit

The iTank 2 is part of the GTi platform: it takes the GTi coils 5 Pack and the GTi Dual Mesh coils 5 Pack, but not GTX coils. A broken glass is replaced with the iTank 2 8ml glass. This tank is also sold fitted in the Target 80 iTank 2 kit. More models are in our tanks, and something to power it in our box mods.

Frequently asked questions

What power does the iTank 2 need?

With the 0.2ohm coil, set between 60 and 75W; with the 0.4ohm, between 50 and 60W. A box mod that reaches at least 75W lets you enjoy both.

How do I prepare a new coil?

After installing it, fill the tank and let the cotton soak for a few minutes. Then take a few puffs at the lowest recommended power before going up: this avoids the burnt taste of the first tries.