Vaporesso VM Tank

A understated tank for mouth-to-lung vaping

The VM Tank from Vaporesso is made first and foremost for mouth-to-lung inhalation (MTL): the vapour stays in the mouth for a moment before being inhaled, a gesture close to that of a cigarette. With its mesh coil, it can also open up to a slightly airy draw (RDL). It works at moderate power, which makes it a good companion for a small box mod or a first tank setup.

Two sizes are offered. The D22 version is 22mm in diameter and holds 2ml: it stays slim on a narrow box mod. The D25 version, 25mm wide, holds 3ml to go longer between refills. On both, the top unscrews to pour in the e-liquid and a ring at the bottom sets the air inlet.

Highlights

• Two diameters to choose from depending on the width of your box mod
• A CCELL ceramic coil and a mesh coil supplied
• Top filling
• Adjustable airflow ring at the base
• Low power needed, from 10 to 22W depending on the coil

In the box

• 1 x VM Tank (D22 or D25 depending on the version chosen)
• 1 x EUC CCELL 1ohm coil
• 1 x EUC Meshed 0.6ohm coil

Compatible coils

The VM Tank uses Vaporesso's EUC coil platform. To restock it with coils, the EUC coils 5 Pack come in several values: to keep a tight draw, stick with a high value such as 1ohm. Find all our coils, the other tanks and, to carry it, a box mod from our box mods category.

Frequently asked questions

D22 or D25: which version should I take?

Measure the top of your box mod. The D22 lines up with slim models, the D25 suits wider box mods and holds 1ml more.

Which coil should I start with?

The CCELL 1ohm, set between 10 and 14W, gives a tight draw and a soft vapour. The Meshed 0.6ohm, between 16 and 22W, brings more vapour and a slightly freer draw.