Geekvape P Series Replacement Coils - 5 Pack

Coils for Geekvape's powerful pods

The P Series coils from Geekvape equip the devices of the Aegis Boost Pro line, including our Aegis B100 21700 pod kit, as well as the Aegis Eteno E100 pods. These low-value coils are made for direct-to-lung (DL) inhalation: air flows freely, the vapour heads to the lungs in one go and the cloud is generous. They are packed in 5s.

Choosing your value

• 0.15ohm XM (70 to 85W): the most powerful, supplied as standard with the Aegis Boost Pro 2
• 0.2ohm (60 to 70W): the coil installed in the B100 21700 kit, also recognised by the Aegis Boost Pro and the XP77
• 0.4ohm (50 to 60W): the kit's second coil, a little less power-hungry, which also suits the Obelisk 60
• 0.5ohm (40 to 50W): the most power-efficient, recommended for the Obelisk 60

Compatibility

On the B100 21700 kit, Geekvape supplies the 0.2ohm and the 0.4ohm: these are the two values whose compatibility is confirmed for this model. The Eteno E100 empty pods also take P Series coils. Beware of names: despite its letter, the P Subohm tank does not take these coils but the Z Series coils. The other families are in the coils section.

In the box

• 5 x P Series coils of the chosen value

Frequently asked questions

When should I replace a P Series coil?

As soon as the flavour turns flat, the vapour weakens or a burnt taste appears. At high power and with sugar-rich e-liquids, expect more frequent changes.

How do I fit it without leaks?

Check that the orange seals are properly in place, push the coil in straight into the pod, then wet the cotton before filling. Let it rest for a few minutes before the first puff.