Geekvape P Subohm Tank

An air ring placed in the middle of the tank

The P Subohm tank from Geekvape is aimed at vapers who practise direct-to-lung (DL) inhalation: the vapour is pulled in one go to the lungs, with a full draw and plenty of volume. Its originality is striking: the airflow ring is placed neither at the top nor at the bottom, but in the centre, with three slots that you open more or less to dose the air.

This design splits the e-liquid into two reserves, for a total capacity of 5ml. To fill, a quarter turn on the top frees the filling openings, without taking anything apart. The wide 810 drip tip lets dense vapour through, and the 26mm diameter suits most boxes.

Key features

• Adjustable central airflow on three slots
• Two e-liquid reserves, 5ml in total
• Quarter-turn top filling
• 810 drip tip with a wide opening
• Z Series coils, the same as those of the Zeus tanks

In the box

• 1 x P Subohm tank
• 1 x Z 0.2ohm coil (installed)
• 1 x Z 0.4ohm coil
• 1 x 810 drip tip
• Spare glass
• 1 x bag of spare parts

Compatible coils

Contrary to what its name suggests, the P Subohm does not take P Series coils: it works with the Z Series coils 5 Pack. Geekvape's official guide rules out a single value in the range, the Z 0.25ohm, which is not intended for this model. If the glass cracks, the P Subohm glass steps in. Plan for a box that goes up to at least 80W, to be chosen in the box mods section, or compare with our other tanks.

Frequently asked questions

What power for the supplied coils?

Geekvape recommends 70 to 80W for the Z 0.2ohm and 50 to 60W for the Z 0.4ohm. Start at the bottom of the range and increase gradually.

How do I prepare a new coil?

Place a few drops of e-liquid on the visible cotton, fill the tank, then wait a few minutes before the first puff. For the first few minutes, stay at moderate power.