Vaporesso GTX V2 Replacement Coils - 5 Pack

Mesh coils for the whole GTX range

The GTX V2 coils from Vaporesso are sold in packs of 5 and use a mesh heating surface, which heats quickly and evenly for a true flavour. Each value matches a way of vaping: the lower the resistance, the more power is needed and the airier the draw. The recommended power range is engraved on each coil.

Which value should you choose?

• 0.15ohm (60 to 75W) and 0.2ohm (45 to 60W): direct-to-lung inhalation (DL), lots of vapour
• 0.3ohm (32 to 45W) and 0.4ohm (26 to 32W): a more moderate airy draw
• 0.6ohm (20 to 30W): semi-tight draw, a good compromise
• 0.8ohm (12 to 20W) and 1.2ohm (8 to 12W): mouth-to-lung inhalation (MTL), close to the feel of a cigarette

Compatible hardware

These coils fit the GTX GO 40 and GTX GO 80 kits, the Luxe XR Max and Luxe XR Max 2 pods with the empty Luxe XR pods, as well as the XTank T tank from the GTX One Pro kit. Always check that your device's power matches the value chosen: on the XTank T, stay between 0.4ohm and 1.2ohm. Compared with the GTX V1 coils, the V2 version adds a silicone seal: it is the one you need on the GTX GO. Note that GTi coils are not interchangeable with GTX ones. All our references are in the coils category.

Using a new coil properly

Before the first puff, put a few drops of e-liquid on the cotton visible through the openings, fill the pod or the tank, then wait five minutes. Start at the bottom of the power range and go up gradually. Replace the coil as soon as the flavour fades or a burnt taste appears.