Vaporesso XTank T

The XTank T, a slender tank for tight vaping

The XTank T tank from Vaporesso comes with the GTX One Pro kit and is also sold on its own, to replace the one in the kit or dress another box mod. At 22.4mm in diameter, it keeps a slim silhouette. It is aimed at mouth-to-lung inhalation (MTL: the vapour goes through the mouth first, as with a cigarette) and slightly airy draw (RDL).

Air enters from the top of the tank and is set precisely with the ring, while Vaporesso's SSS design aims to limit leaks. The 3ml tank fills from the top. The coil then makes the difference: the 1.2ohm offers a tight draw and measured consumption, the 0.6ohm, fitted as standard, a freer draw and more vapour.

Highlights

• Slim 22.4mm silhouette, discreet on a compact box mod
• Top air inlet, precisely adjustable
• Top filling
• Four GTX coil values can be used, from 0.4 to 1.2ohm
• Silver, Black or Grey colours

In the box

• 1 x XTank T tank
• 1 x GTX Mesh 0.6ohm coil (fitted)
• 1 x GTX Mesh 1.2ohm coil
• 1 x spare glass
• 2 x O-rings
• 1 x silicone filling plug
• 1 x user manual and warranty card

Compatible coils and parts

The XTank T accepts the GTX V2 coils 5 Pack in 0.4, 0.6, 0.8 and 1.2ohm. The lower values in the GTX range are not intended for this tank, and GTi coils do not fit it. If the glass cracks, order the XTank glass. To compare, browse our tanks, our coils or our box mod kits if you prefer a set that is ready to vape.

Frequently asked questions

What power should I set for each coil?

On this tank, Vaporesso gives 26 to 32W for the 0.4ohm, 20 to 26W for the 0.6ohm, 12 to 16W for the 0.8ohm and 8 to 12W for the 1.2ohm. Set the low end of the range first, then fine-tune to your taste.

Can it be fitted on a box mod other than the GTX One Pro?

Yes, it screws onto any box mod with a 510 connection. Just check that the box mod covers the power required by the installed coil.