Geekvape Wenax K1 Pod Kit

Wenax K1: a compact pod for a tight vape

The Wenax K1 pod kit from Geekvape is a small model in the Wenax range, designed for mouth-to-lung inhalation (MTL): the vapour is first held in the mouth then inhaled, a gesture close to that of a cigarette. Its built-in 600mAh battery makes it light and easy to carry. It is aimed above all at people starting out, or who vape in short breaks through the day.

It stays easy to operate. It fires on draw, or with its round button if you prefer to keep control. This button also gives access to three power levels, between 9 and 16W, to adapt the heating to your e-liquid. The 2ml pod fills from the side, and the fixed air inlet ensures a steady draw, with no setting to hunt for. Geekvape estimates that a pod lasts about 300 to 400 puffs.

Highlights

• Compact, light format to slip into a pocket
• Activation by inhaling or by button
• Three power levels up to 16W
• Side filling of the pod
• Two pods supplied to compare two sensations
• Indicator light and USB-C charging

In the box

• 1 x Wenax K1
• 1 x K1 2ml 0.8ohm pod (fitted)
• 1 x K1 2ml 1.2ohm pod
• 1 x USB-C cable

Compatible pods

The K1 works with Geekvape K1 pods, offered in 0.8ohm, 1ohm and 1.2ohm; these are also the pods of the Wenax K1 SE and Wenax K2. To keep spares, choose the Wenax K1 pods 3 Pack. Prefer a pen with a bigger battery? Look at the Wenax S3 Evo, or browse the pod kits category and the pods category.

Frequently asked questions

What is the difference between the two supplied pods?

The 0.8ohm, fitted as standard, is used from 12 to 16W and produces more vapour. The 1.2ohm works between 10 and 12W, for a softer puff.

Is the K1 suitable for a first purchase?

Yes. It has no menu or airflow to set: you fill the pod, wait a few minutes for the cotton to soak, then draw.

When should I replace the pod?

The coil is built into the pod: replace the whole thing when the taste goes flat or a burnt note appears.