Geekvape P Subohm Replacement Glass

The two glass sections of the P Subohm tank

The tank of the P Subohm tank from Geekvape is not made of a single tube: it assembles two straight glass rings, one taller than the other. This replacement glass brings together both parts, for a total capacity of 5ml once the tank is reassembled.

A knock against the edge of a table is enough to crack a glass. Rather than replacing the whole tank, change only the damaged part and keep the other ring aside for next time.

In the box

• 1 x set of 2 straight glass sections for the P Subohm (one tall, one short)

Compatibility

These glass sections are cut for the P Subohm. Despite its name, this tank does not take P Series coils: it works with the Z Series coils, except the 0.25ohm. More glass awaits in the replacement glass section.

Frequently asked questions

How do I replace a glass on the P Subohm?

Empty the tank, remove it from the box, then take it apart over a soft surface. Note the position of the tall glass and the short glass before taking them out. Fit the new part, checking that each seal stays seated in its groove, and screw back by hand, without tightening hard.

Do I need to change both glass sections at the same time?

No. Only the cracked ring needs replacing; the second becomes a spare part.