Geekvape Q 3ml Replacement Pods - 3 Pack

More reserve, side filling

The Q 3ml pods from Geekvape are sold in threes and hide a mesh coil inside. With one millilitre more than the Q 2ml pods, they last longer between fills. The e-liquid is poured through an opening on the side of the pod. When the flavour fades, the whole pod is replaced: no coil to take apart.

Q 3ml or Q 2ml: the differences

• Filling: from the side for the 3ml, from the top for the 2ml.
• Values: 0.4, 0.6 and 0.8ohm in 3ml; the 1.2ohm exists only in 2ml.
• Devices: the 3ml is listed for recent Q pods; the 2ml fits the whole range, including the first models.

Which value should I choose?

• 0.4ohm (25 to 30W) and 0.6ohm (18 to 25W): restricted direct-to-lung (RDL) draw, air flows more freely and the vapour gains volume.
• 0.8ohm (12 to 18W): loose mouth-to-lung inhalation (MTL: the vapour stays in the mouth for a short moment, as with a cigarette), with a slightly less tight draw.

Compatible pods

Geekvape lists them for the Sonder Q2 (including the Sonder Q2 Tornadoliq set), the Sonder Q3, the Wenax Q2, the Wenax Q Ultra, the Aegis Hero Q and the Digi Q Vista. The Wenax Q, the Wenax Q Mini and the first Sonder Q are only listed with the 2ml pods. The other refills are in the pods section.

Frequently asked questions

Can I use these pods on a Wenax Q or a Wenax Q Mini?

Geekvape does not list them for these two models, nor the 0.4ohm value. For those, choose the Q 2ml pods in 0.6, 0.8 or 1.2ohm.

How do I get a new pod off to a good start?

Fill it, put it back in place and let the cotton soak for a few minutes before the first puff. On an adjustable-power pod, start from the bottom of the recommended range for the chosen value.