Aspire Pulz Pro Pod Kit

Pulz Pro: an adjustable pod that stays simple

The Pulz Pro pod kit from Aspire suits vapers who want more freedom than an automatic pod without moving up to a box mod. Short and wide, it stands 97mm tall and sits well in the hand. Its 0.91 inch OLED screen shows the power, battery level, coil value and puff count.

You can fire it by drawing or by pressing the button, depending on your habits. Power adjusts from 5 to 30W, and the built-in 1400mAh battery charges over USB-C, up to 2A. The kit comes with a 0.6ohm Minican pod of 3ml, filled from the side, used between 15 and 18W. An airflow slider lets you go from a tight mouth-to-lung (MTL) draw, where the vapour stays in the mouth as with a cigarette, to a more open draw that lets more vapour through.

Key features

• Two firing modes: draw or button
• Adjustable power from 5 to 30W
• OLED screen with puff counter
• Adjustable airflow
• Takes every pod in the Minican series

In the box

• 1 x Pulz Pro battery
• 1 x Minican 0.6ohm pod (3ml)
• 1 x USB-C cable
• 1 x user manual

Compatibility

To replace the pod in the kit, get the Minican Replacement Pods - 2 Pack, offered in several resistance values. You will find other adjustable pods in the pod kits category and all the consumables in the pods category.

Frequently asked questions

What power should I use with the supplied pod?

Aspire recommends 15 to 18W for the Minican 0.6ohm. Start at 15W and go up gently if you want more vapour.

Which Minican pods fit the Pulz Pro?

The whole Minican series is compatible. A value higher than 0.6ohm gives a softer, tighter draw, to be used at a lower power.

Do I have to press the button to vape?

No: drawing is enough to start heating. The button is still there if you prefer to control each puff.