Geekvape J Replacement Pods - 2 Pack

Refills for the Digi pods

The J pods from Geekvape are sold in twos and contain their coil directly: you simply remove the used pod and fit the new one. They equip two pod mods from the brand, the Digi Pro and the Digi Max. Five values exist, to go from a tight vape to a much airier draw.

Which coil for which device?

• 0.2ohm (50 to 60W): reserved for the Digi Max, which needs it for its 80W Boost mode. It does not suit the Digi Pro.
• 0.4ohm (23 to 28W) and 0.6ohm (16 to 21W): more vapour, with restricted direct-to-lung (RDL) draw, the puff being inhaled more directly.
• 0.8ohm (12 to 17W) and 1.2ohm (8 to 12W): mouth-to-lung (MTL) inhalation, the vapour passes through the mouth first, as with a cigarette.

Both devices come with a 0.4ohm installed and a 0.6ohm spare: if you like this sensation, stay with these values.

J pod or J coils?

Do not confuse these pods, whose coil is built in, with the J Series coils sold separately: those fit in the empty JR pod and do not go into a J pod. More models are shown in the pods section.

Frequently asked questions

Can I use the 0.2ohm on a Digi Pro?

No. Geekvape limits the Digi Pro to 0.4, 0.6, 0.8 and 1.2ohm pods; the 0.2ohm is intended for the Digi Max.

How do I start a new pod?

Once filled, give it a few minutes for the wick to soak up the e-liquid. Then set a power at the bottom of the recommended range, and go up little by little until you reach the result you like.