Aspire Fluffi Pro Pod Kit

The Fluffi Pro, the beefed-up version of the Fluffi range

The Fluffi Pro pod kit from Aspire takes the tube format of the Fluffi series and adds a big built-in 2800mAh battery, a colour screen and adjustable power from 11 to 40W. It is aimed at vapers who want one device for the whole day, with no battery to manage, and who like being able to change draw style depending on the moment.

Two 3.5ml pods are supplied. The 0.4ohm, already in place, is a dual mesh grid designed for 30 to 40W: it gives dense vapour in direct-to-lung (DL, the vapour goes straight to the lungs). The 0.6ohm, recommended between 17 and 24W, lends itself to a more restricted in-between draw (RDL). If you prefer mouth-to-lung (MTL, in two steps like a cigarette), the Fluffi 1ohm pods also fit the device. The airflow ring on the side fine-tunes the air passage, and filling is from the side of the pod.

In use, three firing modes are offered: by draw, by button, or both at once. Charging is through a 2A USB-C port.

Key features

• Built-in 2800mAh battery, nothing to buy separately
• 1.47 inch TFT colour screen to read power and charge state
• Power from 11 to 40W, matched to each pod
• Compatible with all Fluffi pods, from the 1ohm to the 0.4ohm dual mesh
• Firing by draw, by button or mixed

In the box

• 1 x Fluffi Pro device
• 1 x Fluffi Pro 0.4ohm 3.5ml pod (installed)
• 1 x Fluffi Pro 0.6ohm 3.5ml pod
• 1 x USB-C cable
• 1 x user manual

Compatibility

To replace the pods in the kit, take the Fluffi Pro Replacement Pods - 2 Pack in 0.4 or 0.6ohm. The single-grid Fluffi Replacement Pods - 2 Pack (0.6 or 1ohm) also fit, for a softer vape. The other models are in our pod kits and pods categories.

Frequently asked questions

What is the difference from the standard Fluffi?

The Fluffi Pro goes much higher in power, has a colour screen and a battery nearly twice as large. It accepts the same pods, so you can keep your Fluffi pods if you move up to the Pro.

Which pod should I choose to quit cigarettes?

Go for a Fluffi 1ohm pod, set at low power with the airflow partly closed: the draw stays tight. The supplied 0.4 and 0.6ohm give more vapour.

How do I avoid a burnt taste on a new pod?

After filling, let the pod rest a few minutes so the cotton soaks, then start at the bottom of the stated power range before going up.